A Full 3d Printed Toyota 22re Engine & 5 Speed 4×4 Offroad Transmission


via

Completely reverse engineered Toyota 22RE 4 cylinder engine. Can completely print a fully rotating model. Working crank, pistons, and valve train. The valves open and close!!!. It may not be the most exciting engine but its the only one I had in my garage.

source/image(PrtSc): Ale Fusi

Great if you want to learn about engines and how the moving parts in them work.All parts are printed except for a few bearings and fasteners.More than 3 days of total print time.The block alone was 34 hours.

This is the 5 speed transmission that comes bolted to the back of a 22RE. This is the 4WD version of the transmission so it has a mounting surface to bolt a transfer case to. The transfer case will be the next thing I will upload.

Advertisement

Fully working. All 5 speeds plus reverse. It uses a good amount of 3mm rod and 623zz bearings. M2.5 x 5mm set screws and nuts were used due to the small size of some of the parts.The transmission works exactly like most manual transmissions found in any car or truck.

https://ift.tt/2J7d8js
LihatTutupKomentar